If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to see similar items on eBay, and to buy.
The AM series being commonly used by many broadcasting studios, including the BBC and ITV.
Primarily designed for Rogers LS 3/5a. But used with many other monitor loudspeakers.
Internally mounted switch that enables the user to select a flat frequency response for general use or a corrected frequency response to match the characteristics of the rogers LS3/5a loudspeaker.
TYPICAL HH AM8/12 SPECIFICATIONS:
Output power: 30w / 15 ohm. 45w / 8 ohm. 75w / 4 ohm
THD: < 0.1% (25w / 8 ohms)
Input Impedance: 10k ohms (balanced)
Input sensitivity: 0-25v RMS for full output into 15 ohms
Noise: -60dB (20hz-20khz)
S/N ratio: 80dB RMS (Relative 25 watt into 15 ohms)
Damping factor: >100 ref 7.5 ohms load at 100hz
Slew rate: 5v / uS
Protection: proof against short and open circuit
Mains input: 240, 230, 220, 210, 115 a.c. 50 / 60 Hz
(selectable on rear panel…pull the dial knob outwards then twist to desired voltage then push back inwards)
Mains input connector: Neutrik / cannon l.n.e.
Balanced input
Signal input connectors: 1/4 Jack B gauge (balanced)
darlington output stage
Loudspeaker o/p connector: plessey 11 pin.
Ambient temperature: up to 50 C without forced ventilation
Dimensions: 247mm x 155mm x 89mm.
Weight: 4.1 kgs per amplifier. (Unpacked)
If you buy after clicking affiliate links on this site we might receive a commission from companies such as eBay, Amazon etc This does not affect the price you pay.
Click here to buy, and to see similar items on eBay
Category: Sound and Vision:Home Audio and HiFi Separates:Amplifiers and Pre-Amps
Location: Middlesbrough